email us

Why is it called FATTY CREAM?

healthE™ Fatty Cream is an OIL-IN-WATER EMULSION

What is an EMULSION?

Emulsions are two-phase systems in which one liquid is dispersed throughout another liquid in the form of small droplets. Where oil is the dispersed phase and an aqueous solution is the continuous phase, the system is designated as an Oil-in-Water (O/W) emulsion (eg fat in milk). Conversely, where water or an aqueous solution is the dispersed phase and oil or oleaginous material is the continuous phase, the system is designated as a Water-in-Oil (W/O) emulsion. Emulsions are stablilised by emulsifying agents that prevent coalescence, the merging of small droplets into larger droplets and, ultimately, into a single separated phase. Emulsifying agents (surfactants*) do this by concentrating in the interface between the droplet and the external phase and by providing a physical barrier around the particle to coalesce. Surfactants also reduce the interfacial tension between phases, thus increasing the ease of emulsification upon mixing

Natural, semisynthetic, and synthetic hydrophilic polymers may be used in conjunction with surfactants in Oil-in-Water (O/W) emulsions as they accumulate at interfaces and also increase the viscosity of the aqueous phase, thereby decreasing the rate of formation of aggregates of droplets. Aggregation is generally accompanied by a relatively rapid separation of an emulsion into a droplet-rich and droplet-poor phase. Normally the density of an oil is lower than that of water, in which case the oil droplets and droplet aggregates rise, a process referred to as creaming. The greater the rate of aggregation, the greater the droplet size and the greater the rate of creaming

The water droplets in a Water-in-Oil (W/O) emulsion generally sediment because of their greater density.

The consistency of emulsions varies widely, ranging from easily pourable liquids to semisolid creams. Generally Oil-in-Water (O/W) creams prepared at high temperature, where they are fluid, and cooled to room temperature, whereupon they solidify as a result of solidification of the internal phase. When this is the case, high internal-phase volume to external-phase volume ration is not necessary for semisolid character, and, for example, stearic acid creams, dermatoligical creams or moisturising creams are semisolid with as little as 15% internal phase.

Any semisolid character with Water-in-Oil (W/O) emulsions generally is attributable to a semisolid external phase.



As of the date of preparation of this document, the foregoing information is believed to be accurate and is provided in good faith. However, no warranty or representation with respect to such information is intended or given.



fatty cream 500g.jpg